60V CORDLESS HEDGE TRIMMER HT60B00 Owner’s Manual TOLL-FREE HELPLINE: 1-855-345-3934 www.GreenWorksTools.com Read all safety rules and instructions carefully before operating this tool.
CONTENTS Contents............................................................................................................................... 2 Specifications....................................................................................................................... 2 Important Safety Instructions ............................................................................................... 3 Symbols..............................................................................................
IMPORTANT SAFETY INSTRUCTIONS WA R N I N G Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire, and/or serious injuries. Save all warnings and instructions for future reference. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 1. WORK AREA SAFETY A. Keep work area clean and well lit. Cluttered or dark areas invite accidents. B.
IMPORTANT SAFETY INSTRUCTIONS control of the power tool in unexpected situations. F. Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewelry, or long hair can be caught in moving parts. G. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of these devices can reduce dustrelated hazards. 4. POWER TOOL USE AND CARE A.
IMPORTANT SAFETY INSTRUCTIONS 6. SERVICE A. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. HEDGE TRIMMER SAFETY WARNINGS • Use both hands when operating the hedge trimmer. Using one hand could cause loss of control and result in serious personal injury. • Keep all parts of the body away from the cutter blade. Do not remove cut material or hold material to be cut when blades are moving.
SYMBOLS Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the product better and safer.
SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING DANGER Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. WARNING Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury.
KNOW YOUR HEDGE TRIMMER Auxiliary handle Guard Safety lock button Rear handle Blade Battery release button Battery pack Rotating handle release Blade cover Trigger switch FIG.1 KNOW YOUR HEDGE TRIMMER (See Figure 1.) The safe use of this product requires an understanding of the information on the product and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules.
ASSEMBLY UNPACKING • This product requires no assembly. • Carefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included. • Inspect the product carefully to make sure no breakage or damage occurred during shipping. • Do not discard the packing material until you have carefully inspected and satisfactorily operated the product. • If any parts are damaged or missing, please call 1-855-345-3934 for assistance.
OPERATION To install the battery (See Figure 2.) IMPORTANT! The battery pack is not charged when it is purchased. Before using the hedger for the first time, place the battery pack on the battery charger and charge. Make sure to read all safety precautions, and follow the instructions in the Battery Charger section. 1. Align the grooves (3) of the battery pack (1) with the cavity in the handle housing. 2. Grasp the rear handle (2) firmly. 3.
OPERATION STARTING AND STOPPING HEDGE TRIMMER (See Figure 3.) 1. Ensure the battery is properly installed in the hedge trimmer. 2. Slide the safety lock button (1) into the handle and hold. 3. Squeeze the trigger switch (2). The hedge trimmer will turn ON. 4. Release the safety lock button. The hedge trimmer will stay on as long as the trigger switch is held. 5. The hedge trimmer will stop if you release the trigger switch.
OPERATION USING THE ROTATING REAR HANDLE (See Figure 4.) 1. Place the hedge trimmer on a flat and even surface. 2. Make sure that you released the trigger. 3. Pull the rotation lever and begin turning the rear handle. Release the rotation lever and turn the handle 90 degrees to either side until it clicks into place and the lever locks in. 4.
BATTERY & CHARGER MAINTENANCE CHARGING PROCEDURE NOTE: The battery is not shipped fully charged. It is recommended to fully charge before first use to ensure that maximum run time can be achieved. This lithium-ion battery will not develop a memory and may be charged at any time. Low voltage charging: If the battery has been stored with little to no charge for a long period of time, the charger will go into recovery mode, which will take 20 hrs to fully charge the battery.
BATTERY & CHARGER MAINTENANCE CHARGER MOUNTING 1. This charger can be installed hanging on a wall using two #8 screws (not included). 2. Locate the placement for the charger to be wall mounted. 3. If fastening to wood studs use 2 wood screws (not included). 4. Drill two holes on center 4.0 in. apart ensuring that they are vertically aligned. 5. If fastening to drywall use wall anchors (not included) and screws to secure the charger to the wall. 6.
MAINTENANCE WA R N I N G To avoid risk of fire, electric shock, or electrocution: • Do not use a damp cloth or detergent on the battery or battery charger. • Always remove the battery pack before cleaning, inspecting, or performing any maintenance on the hedge trimmer. Cleaning • Wipe the outside of the hedge trimmer with a dry, soft cloth. Do not hose down or wash with water. • Scrape the guard to remove dried clippings and mud. • Brush or blow dust, debris, and grass clippings out of the air vents.
ENVIRONMENTALLY SAFE BATTERY DISPOSAL The following toxic and corrosive materials are in the batteries used in this hedge trimmer battery pack: Lithium-Ion, a toxic material. WA R N I N G All toxic materials must be disposed of in a specified manner to prevent contamination of the environment. Before disposing of damaged or worn out Lithium-Ion battery packs, contact your local waste disposal agency, or the local Environmental Protection Agency for information and specific instructions.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Motor fails to start Battery is not secure. when switch trigger is depressed. To secure the battery pack, make sure the latches on the top of the battery pack snap into place. Battery is not charged. Charge the battery pack according to the instructions included with your model. Motor runs,but cutting Hedger damaged. Do not use blades do not move. hedge trimmer. Call for technical service. Hedge trimmer smokes during operation. Hedger damaged.
LIMITED WARRANTY GREENWORKS™ hereby warranties this product, to the original purchaser with proof of purchase, for a period of four (4) years against defects in materials, parts or workmanship. GREENWORKS™, at its own discretion will repair or replace any and all parts found to be defective, through normal use, free of charge to the customer.
EXPLODED VIEW 2 1 3 4 19
PARTS LIST ITEM NO. 1 2 3 4 PART NO.
Greenworks Tools PO Box 1238 Mooresville, NC 28115 TOLL-FREE HELPLINE: 1-855-345-3934 Rev: 00 (10-10-16) Printed in China on 100% Recycled Paper
