Use and Care Guide

8.2 REPLACE THE SCRAPER
2
1
1
WARNING
Use only approved replacement scrapers.
WARNING
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Remove the screws(1) from each side plate.
2. Remove and discard the old scraper.
3. Install the new scraper.
4. Put in the mounting screw(2) and spacers and
tighten them.
8.3 REPLACE THE IMPELLER
1
2
3
4
5
6
WARNING
Use only approved replacement scrapers.
1. Remove the screws(1) and side wear pad(2) of left
and right side covers.
2. Remove the nut(3).
3. Remove the belt(4).
4. Remove the the large pulley(5) with a socket wrench
(23 mm).
5. Pull the axle(6) and remove the old impeller.
6. Install the new impeller.
7. Reinstall the components.
8.4 STORE THE MACHINE
• Clean the machine before storage.
• Make sure the engine is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
9 TROUBLESHOOTING
Problem Possible cause Solution
The handle is
not in position.
The bolts are not
engaged correct-
ly.
Adjust the height
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
14
English
EN