EN CORDLESS POLESAW OPERATOR MANUAL ES PODADORA DE ALTURA INALÁMBRICA MANUAL DEL OPERADOR PSF303 www.greenworkstools.
English 1 1.1 2 2.1 3 3.1 3.2 4 5 6 7 8 8.5 8.6 8.7 8.8 Description......................................... 2 Overview........................................................... 2 Introduction....................................... 2 Intended use....................................................... 2 9 General power tool safety warnings............................................. 2 9.1 9.2 9.3 9.4 9.5 General safety rules........................................... 2 Child safety...............
English EN 1 DESCRIPTION 1.1 OVERVIEW 3 WARNING Do not operate near electrical power lines. The unit has not been designed to provide protection from electric shock in the event of contact with overhead electric lines, Consult local regulations for safe distances from overhead electric power lines and ensure that the operating position is safe and secure before operating the saw chain pole pruner. WARNING Read all safety warnings and all instructions.
English • • • • • • • • • • • • Store Idle Appliances Indoors – When not in use, appliances should be stored indoors in dry, and high or locked-up place – out of reach of children. Maintain Appliance With Care – Keep cutting edge sharp and clean for best performance and to reduce the risk of injury. Follow instructions for lubricating and changing accessories. Inspect appliance cord periodically, and if damaged, have it repaired by an authorized service facility.
English EN • Use extreme care when approaching blind corners, doorways, shrubs, trees, or other objects that may obscure your view of a child who may run into the path of the machine. 4 SYMBOL MEANING DANGER Indicates an imminently hazardous situation,which, if not avoided, will result in death or serious injury. WARNING Indicates a potentially hazardous situation,which, if not avoided, could result in death or serious injury.
English EN WARNING WARNING • • If the battery pack cracks or breaks, with or without leaks, do not recharge it and do not use. Discard it and replace with a new battery pack. DO NOT TRY TO REPAIR IT! To prevent injury and risk of fire, explosion, or electric shock, and to avoid damage to the environment: • • • • • • • • 7 • Cover the terminals of the battery with heavy-duty adhesive tape. DO NOT try to remove or destroy any of the battery pack components. DO NOT try to open the battery pack.
English EN 8.3 ASSEMBLE THE GUIDE BAR AND THE CHAIN 9. Install the chain cover. 10. Tighten the chain. Refer to Adjust the chain tension. 1. Loosen the chain cover by turning the bar nut (8) counterclockwise. 2. Remove the chain cover (14). 11. Tighten the bar nut when the chain is correctly tensioned. NOTE If you start the chain saw with a new chain, have a test for 2-3 minutes. A new chain gets longer after the first use, examine the tension and tighten the chain if necessary. 3.
English 8.6 CUTTING PREPARATION IMPORTANT Examine the chain tension before each use. Before you start to cut, make sure that • • EN Wear heavy gloves for maximum grip and protection. Maintain a proper grip on the machine during operation. 9.1 EXAMINE THE CHAIN OIL NOTE • Use your right hand grip on the rear handle while your left hand grip on the pole shaft. • Keep your body to the left of the chain line.
English EN WARNING Make sure that there is nothing or nobody in the area where the branches fall. • • • • Stand opposite the branch you will cut. Start to cut the higher branches. Then cut the lower branches. Cut downwards to prevent the bar from jamming. 9.5 LIMB TREE BRANCHES Limbing is to remove the branches from a fallen tree. A NOTE A It is not necessary to remove the chain cover to adjust the chain tension. 2.
English • EN There is too much space between the drive links and the rivets. The cut speed is slow Sharpening the chain many times but it does not increase the cutting speed. The chain is worn. • • 10.3 GUIDE BAR MAINTENANCE 2. Sharpen the cutters corner with a 5/32 in. (4 mm) diameter round file . 3. Sharpen the top plate, side plate and depth gauge with a flat file. NOTE Make sure that it is turned over periodically to keep symmetrical wear on the bar. 1.
English EN • • Clean all unwanted material from the machine. Make sure that the storage area is • • 12 Not available to children. Away from agents which can cause corrosion, such as garden chemicals and de-icing salts. TROUBLESHOOTING Problem Possible cause The machine does The poles are not not start. assembled correctly. Possible cause The motor runs, but the chain does not cut correctly, or the motor stops after around 3 seconds. 1. Release the When you use the trigger. machine under 2.
English 14 LIMITED WARRANTY 3 YEAR AÑOS LIMITED WARRANTY GARANTÍA LIMITADA Greenworks hereby warranties this product, to the original purchaser with proof of purchase, for a period of three (3) years against defects in materials, parts or workmanship. Greenworks, at its own discretion will repair or replace any and all parts found to be defective, through normal use, free of charge to the customer.
English EN 15 EXPLODED VIEW 12 4 14 5 7 13 6 8 9 10 11 3 2 1 No Part No. . Qty Description No Part No. .
