Operating Guide
28
MAINTENANCE
C A U T I O N
Always wear gloves when handling the bar and chain; these components are sharp and may
contain burrs.
W A R N I N G
Never touch or adjust the chain while the motor is running. The saw chain is very sharp; always
wear protective gloves when performing maintenance to the chain to avoid possible serious
lacerations.
Chain Combinations section later in this manual.
• Remove the battery from the chain saw.
• Rotate the chain cover lock bolt counterclockwise and remove knob and sleeve .
• Remove the chain cover.
• Remove the bar and chain from the mounting surface.
• Remove the old chain from the bar.
• Lay out the new saw chain in a loop and straighten any kinks. The cutters should face in the
direction of chain rotation. If they face backwards, turn the loop over.
• Place the chai
n drive links into the bar groove as shown.
Fig. 29
Fig. 27 Fig. 28
Mounting
Surface
Chain
Chain Cover
BAR
Chain Cover
Lock Bolt
Chain Tension
Knob
0