Manual

29
Problem Cause Solution
Trimmer
head will not
advance line.
1. The motor shaft or
trimmer head is bound with
grass.
1. Stop the trimmer
,
remove the battery,
and clean the motor shaft and trimmer
head.
2. There is not enough line
on the spool.
2. Remove the battery and replace
the cutting line
;
follow the section “line
replacement”in this manual.
3. The trimmer head is
dirty
.
3. Remove the battery and clean the
spool, spool retainer and spool base.
4. The line is tangled on
the spool
.
4. Remove the battery, remove the line
from the spool and rewind
;
follow the
section "line replacement" in this manual.
5. The line is too short
.
5. Remove the battery and pull the lines
while alternately pressing down on and
releasing the bump knob.
6. Bump head hit on the
grass.
6. Remove bump head hit on the ground.
Line keeps
breaking.
1. Trimmer used incorrectly. 1. Only trim with the tip of the line
,
avoid
stones
,
walls and other hard objects.
Feed the line regularly to maintain full
cutting width.
Grass wraps
around trimmer
head and
motor housing.
1. Cutting tall grass at
ground level
1. Cut tall grass from the top down
,
removing no more than 8 inches in each
pass to prevent wrapping.
Line is not
cutting well
1. The line-cutting blade on
the edge of the guard has
become dull
.
1. Sharpen the line-cutting blade with a
le or replace it with a new blade.
TROUBLESHOOTING