Operating Guide

10
ASSEMBLY INSTRUCTION
BATTERY
IMPORTANT!
The battery pack is not charged when it is purchased. Before using the blower
for the rst time, place the battery pack in the battery charger and charge. Make sure to read all
safety precautions, and follow the instructions in the Battery Charger section.
NOTE:
The battery pack ts into the handle snugly in order to prevent accidental dislodging. It
may require a strong pull to remove it.
To remove (See Figure 2.)
1. Press and hold the latch button (1).
2. Grasp the handle rmly. Pull the battery pack out of the handle.
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or
re:
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before
inspecting, adjusting, or performing maintenance on any part of the blower.
• Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
Fig. 2
WARNING
1
2
To install (See Figure 2.)
1. Align the tongue (3) of the battery pack with the cavity in the handle housing.
2. Grasp the handle rmly (2).
3. Push the battery pack into the handle until both sides lock. The latch button will click
when locked into place.
4. Do not use force when inserting the battery pack. It should slide into place and click.
3