Manual

MAINTENANCE
17
IMPELLOR REPLACEMENT
• Place the pulley back onto
the impellor shaft.
• Replace the pulley support
plate and the 3 retaining
screws.
• Place the lower spring
into position and slide the
side cover up using slight
pressure to hold the spring
in place.
• Be sure to route the belt
correctly, as shown.
• Replace and tighten the
impellor shaft washer and
nut.
• Replace and tighten the
remaining screws and the
nut and washer.
• Replace the 2 spacer
washers on the impellor
shaft.
• Place the upper spring into
position and then nger
tighten the cover plate into
place as shown.
• Re-install the impellor shaft
nut and washer on the right
hand side, and tighten.
• Place the impellor and
shaft back into the front
scoop.
• Replace the 2 screws and 2
washers onto the impellor.
screw and washer
spring
spring
impellor shaft washer and nut
13
15
14
18
21
16
19
22
17
20
23