60V BACKPACK BLOWER BPB60L00 Owner’s Manual TOLL-FREE HELPLINE: 1-855-345-3934 www.GreenWorksTools.com Read all safety rules and instructions carefully before operating this tool.
CONTENTS Contents ...................................................................................................................................2 Product Specifications .............................................................................................................2 Important Safety Instructions ...................................................................................................3 Symbols ........................................................................................
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING (THIS POWER TOOL) WA R N I N G Read and understand all instructions before using this product. Failure to follow all instructions listed below may result in electric shock, fire, and/or serious personal injury. When using an electrical appliance, basic precautions should always be followed, including the following: • Do not allow to be use as a toy. Close attention is necessary when used by or near children.
IMPORTANT SAFETY INSTRUCTIONS • When not in use, product should be stored indoors in a dry, locked place out of the reach of children. • Maintain tool with care. Keep fan area clean for best and safest performance. Follow instructions for proper maintenance. • Keep all parts of your body away from any moving parts and all hot surfaces of the unit. • Check the work area before each use.
IMPORTANT SAFETY INSTRUCTIONS • Under extreme usage or temperature conditions, battery leakage may occur. If liquid comes in contact with your skin, wash immediately with soap and water, then neutralize with lemon juice or vinegar. If liquid gets into your eyes, flush them with clean water for at least 10 minutes, then seek immediate medical attention. Following this rule will reduce the risk of serious personal injury. • Do not use a battery pack or appliance that is damaged or modified.
SYMBOLS Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the product better and safer. SYMBOL NAME DESIGNATION/EXPLANATION V Volts Voltage A Amperes Current Hz Hertz Frequency (cycles per second) W Watts Power Minutes Time Alternating Current Type of current Direct Current Type or a characteristic of current Class II Construction Double-insulated construction.
SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING DANGER Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. WARNING Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. CAUTION Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
KNOW YOUR BLOWER 4 3 2 5 1 Fig. 1 KNOW YOUR BLOWER (See Figure 1.) The safe use of this product requires an understanding of the information on the product and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. 1. BLOWER TUBE The blower tube can be easily installed on the blower without any additional tools. 2. TRIGGER Starts/Stops the flow of air through the blower. 3.
ASSEMBLY UNPACKING This product requires assembly. • Carefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included. • Inspect the tool carefully to make sure no breakage or damage occurred during shipping. • Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool. • If any parts are damaged or missing, please call 1-855-345-3934.
ASSEMBLY WA R N I N G To avoid serious personal injury, the blower tube must be used when operating this unit. NOTE: The blower tube is not assembled on this unit. Installation is required to provide safe and easy use for the operator. WA R N I N G If any parts are damaged or missing do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury.
ASSEMBLY ASSEMBLY (See Fig.2) 1. The flexible tube (B) is connected to the fan outlet tube (A) from the manufacturer. 2. Connect the operating tube (C) to the flexible hose (B) with the hose clamp (D). Use a screw driver (not provided) to loosen and tighten the hose clamp. Turn clockwise to tighten, and counter clockwise to loosen. 3. Open the clamping lever (E). Move the control handle (F) along the tube to the most comfortable position.
ASSEMBLY BATTERY IMPORTANT! The battery pack is not charged when it is purchased. Before using the blower for the first time, place the battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the instructions in the Battery Charger section. To Remove (See Fig 4.) 1. Press and hold the battery release button with firm grip. 2. Grasp the backpack firmly. Pull the battery pack out of the handle.
ASSEMBLY HARNESS ADJUSTMENT A well adjusted backpack blower and harness makes work easier. Adjust the harness to give you the best working stance. Adjust the side straps so the weight is equally distributed across your shoulders. A A Once the blower is properly fitted on your back, pull the ends of the straps downward to tighten the harness. Connect the horizontal chest strap, and pull the end of the strap to tighten. B B Lift the tabs of the adjusters to loosen the straps.
ASSEMBLY PUT ON THE SHOULDER STRAP 2 1 1 1. Adjust the harness straps (1) to the correct length. 2. Adjust chest strap (2) to correct length and fasten it together. The back padding must fit firmly and securely against your back. Harness Removal • Open the quick-release fasteners on the strap. • Loosen the harness straps by lifting the sliding adjusters and then take off the blower. WA R N I N G The backpack blower must be quickly removed in the event of imminent danger.
OPERATION WA R N I N G Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WA R N I N G Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing protection. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries.
OPERATION STARTING/STOPPING THE BLOWER (See Fig 6.) Before start-up, make sure that the blower is in perfect condition to guarantee safe operation. • Squeeze the switch trigger to start. • To change speed, press or release trigger by degrees to increase or decrease the speed. USING CRUISE CONTROL LEVER (See Fig 6.) This blower is equipped with a cruise control function. Please read and understand the function of the cruise control lever. • Squeeze the trigger to start the unit.
OPERATION OPERATING TIPS • • • • • • • • • Ensure that the unit is not directed at anybody or any loose debris before starting the unit. Verify that the unit is in good working condition. Make sure the tubes and guards are in place and secure. To reduce the risk of hearing loss associated with sound level(s), hearing protection is required. Operate power equipment only at reasonable hours—not early in the morning or late at night when people might be disturbed. Comply with times listed in local ordinances.
ENVIRONMENTALLY SAFE BATTERY DISPOSAL The following toxic and corrosive materials are in the batteries used in this blower battery pack: Lithium-Ion, a toxic material. WA R N I N G All toxic materials must be disposed of in a specified manner to prevent contamination of the environment. Before disposing of damaged or worn out Lithium-Ion battery packs, contact your local waste disposal agency, or the local Environmental Protection Agency for information and specific instructions.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE Unit will not start. Battery is not charged. Battery is not secure. SOLUTION Check to ensure the latches are tightly secured into place on the back of the blower and the battery. (Reference Page 12 of the instruction manual). Charge the battery pack according to the instructions included with your battery. Defective power switch. Return to place of purchase or return the unit to a repair center. Unit will not blow. Blocked tube. Clear the blockage.
LIMITED WARRANTY GREENWORKS™ hereby warranties this product, to the original purchaser with proof of purchase, 4 year consumer warranty, 1 year commercial warranty against defects in materials, parts or workmanship. GREENWORKS™, at its own discretion will repair or replace any and all parts found to be defective, through normal use, free of charge to the customer.
EXPLODED VIEW 4 2 6 5 3 1 PARTS LIST IETM NO. PART NO.
Greenworks Tools PO Box 1238 Mooresville, NC 28115 TOLL-FREE HELPLINE: 1-855-345-3934 Rev: 00 (09-20-16) Printed in China on 100% Recycled Paper
