Use and Care Manual

16
C H
A IN
LUBR IC A N T
OPERATION
CONNECTING TO POWER SUPPLY (See Fig. 7)
This chainsaw is designed with a cord retainer that prevents the extension cord from being pulled
loose while using.
• Form a loop with the end of the extension cord.
• Insert loop portion of extension cord through the opening in the side of the rear handle,
and place over cord hitch.
• Slowly pull loop against cord retainer until the slack is removed.
• Plug chainsaw into extension cord.
NOTE: Failure to remove all excess cord slack from extension cord retainer could result in plug loosening
from receptacle.
STARTING AND STOPPING THE CHAINSAW (See Fig. 8)
W A R N I N G
Keep body to the left of the chain line. Never straddle the saw or chain, or lean over past the
chain line.
To start the motor:
• Plug the edger into an AC power outlet.
• Press and hold the Lock-off button and squeeze the switch trigger. The edger will stay
ON as long as the trigger switch is squeezed.
Fig. 6 Fig. 7
OIL
RESERVOIR
CAP
QUICK VIEW
OIL INDICATOR
EXTENSION
CORD