Replacement Part List

ASSEMBLY

W A R N I N G

Never attach or adjust any attachment while power head is running. Failure to stop the motor

may cause serious personal injury.

W A R N I N G

Be certain the knob is fully tightened before operating equipment. Check it periodically for

tightness during use to avoid serious injury.

The straight shaft trimmer attachment connects to the power head by means of a coupler device

• Remove the hanger cap from the attachment shaft.

• Loosen the knob on the coupler of the power head shaft.

• Push in the button located on the straight shaft trimmer attachment. Align the button with the

guide recess on the power head coupler and slide the two shafts together. Rotate attachment

shaft until button locks into the positioning hole.

NOTE: If the buttons do not release completely in the positioning holes, the shafts are not locked

into place. Slightly rotate from side to side until the button is locked into place.

• Tighten the knob securely.

REMOVING THE ATTACHMENT FROM THE POWER HAED

For removing or changing the attachment:

• Stop the power head.

• Remove power cord from power head.

• Loosen the knob.

• Push in the button and twist the shafts to remove and separate ends.