Use and Care Manual
11
ASSEMBLY INSTRUCTION
BATTERY
IMPORTANT! The battery pack is not charged when it is purchased. Before using the hedger
forthersttime,placethebatterypackinthebatterychargerandcharge.Makesuretoreadall
safety precautions, and follow the instructions in the Battery Charger section.
WARNING
Followtheseinstructionsinordertoavoidinjuryandtoreducetheriskofelectricshockorre:
•Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
•Verify that the switch is in the OFF position before inserting or removing the battery pack.
•Verify that the battery pack is removed and the switch is in the OFF position before
inspecting, adjusting, or performing maintenance on any part of the hedger.
•Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
To remove the battery
(See Figure 2.) :
1. Slide the latch button on the battery pack down (3) and hold.
2.Graspthetriggerhandle(2)rmly.Pullthebatterypackoutofthehandle.
NOTE:
Thebatterypacktssnuglyintothehandletopreventaccidentaldislodging.Itmayrequire
a strong pull to remove.
To install the battery
(See Figure 2.):
1. Align the tongue (1) of the battery pack with the cavity in the handle housing.
2.Graspthetriggerhandle(2)rmly.
3. Push the battery pack into the handle until the latch locks into place.
Fig. 2
2
3
1