Operating Guide

OPERATION

REPLACING THE LINE (See Figure 8.)

1. Press the tabs simultaneously on the side of the trimmer head and remove cover and spool.

Fig. 8.1

Cover

Spool

2. Remove any remaining line.

3. Clean dirt and debris from all parts. Replace spool if it is worn or damaged.

4. Replace with a pre-wound spool, or replace line using 10 feet (3 meters) of 0.065 inch (1.65

mm) diameter line.

WARNING

Never use wire, rope, string, etc., which can break off and become a dangerous projectile.

RESPOOLING (See Figure 9.)

1. Bend one end of the line 1/4 of an inch (6 mm).

Fig. 9.1

2. Insert the line into the anchor hole.

Fig. 9.2