User manual

H35.0.02.6C-09 Operating Manual GMH 3250 page 6 of 14
6 Configuration
For configuration of the device press -key for 2 seconds: the main menu of the configuration will be called up.
Use key to select a sub-menu, use the key to actually go into the selected sub-menu and to change parame-
ters.
Use the keys and to set the individual value for the parameter. Press the key again to memorize the
changes ant to change to the main menu. Use key to leave the configuration.
’Read Logger’: Read Out Logger Data
(will be displayed only if data are memorized in the individual value logger mode)
For more information please refer to the chapter ’data logger - how to display
individual values’.
’Set Configuration’: General Device Configurations
Setting general configuration:
Please note: the points marked by * will only be displayed if no data is stored in
the logger.
’Typ’: Selection of Thermoelement Type*
1
ni.cr:
Type K: NiCr-Ni
n:
Type N: NiCrSi-NiSi
S:
Type S: Pt10Rh-Pt
t:
Type T: Cu-CuNi
J:
Type J: Fe-CuNi
’Resolution’: Selection of Display Resolution
1°:
Resolution 1°C
0.1°:
Resolution 0.1°C
Auto:
Resolution is selected automatically
’Unit’: Selection of Temperature Unit °C /°F*
1
°C:
All temperature values in degrees Celsius
°F:
All temperature values in degrees Fahrenheit
’Corr’: Selection of Display Correction Factor *
1
0.950 ... 1.200:
The temperature value (referring to 0°C or.
32°F) will be multiplied by this factor. This factor
will be applied to both sensor values.
off:
Factor is deactivated (=1.000)
’Offset’: Zero Displacement Channel 1 *
1
-10.0°C ... 10.0°C
or
-18.0°F ... 18.0°F
The zero point of the measurement of channel 1
will be displaced by this value.
off:
Zero point displacement is deactivated (=0.0°)
’Offset’: Zero Displacement Channel 2 *
1
-10.0°C ... 10.0°C
or
-18.0°F ... 18.0°F
The zero point of the measurement of channel 2
will be displaced by this value.
off:
Zero point displacement is deactivated (=0.0°)
max
min
2
5
max
min
2
5
max
min
2
5
max
min
2
5
max
min
2
5
max
min
2
5