B07.0.01.6C-01 EA ASYBus-level converter Installation-- and operating manual EBW 3 GRE EISINGER electronic GmbH G D - 93128 Regenstauf, Hans-Sachs-S Straße 26 Tel.: +49 9402 / 9383-0, Fax: +49 9402 / 9383-33, eMail: info@greisinger.
B07.0.01.6C-01 Page 2 of 8 Content 1. Intended use .............................................................................................................................. 3 2. General advice .......................................................................................................................... 3 3. Safety instructions ..................................................................................................................... 3 4. Disposal notes ..........................
B07.0.01.6C-01 Page 3 of 8 1. Intended use The electrically isolated level converter enables the connection of EASYBus sensor module to the USB-interface of your PC. Applications: • Exchange data capture. • Configuration of Logger-function. • Readout measuring data storage of EASYBus-modules. etc. 2. General advice Read through this document attentively and make yourself familiar to the operation of the device before you use it.
B07.0.01.6C-01 Page 4 of 8 5. Installation 5.1 Windows Vista™ For installation of the device drivers a user account with an administrator-authorisation is required. If you haven’t an appropriate authorisation please consult your system administrator. • Insert driver disk into the drive of your PC. • Plug in the USB-plug connector of the EBW 3 into the USB-connection of your PC. • The window “Found new hardware “ appears, there click “Locate and install driver software”.
B07.0.01.6C-01 Page 5 of 8 5.3 Windows 2000 For installation of the device drivers a user account with an administrator-authorisation is required. If you haven’t an appropriate authorisation please consult your system administrator. • Insert driver disk into the drive of your PC. • Plug in the USB-plug connector of the EBW 3 into the USB-connection of your PC. • The “Found New Hardware Wizard” appears. Click button “Next”. • Chose “Search for a suitable driver .....” and click button “Next”.
B07.0.01.6C-01 Page 6 of 8 6. Specification Connection: PC: Standard USB-plug connector (type A) EASYBus: 2-pol screw / plug terminal, RM 3.5 (max. clamping range: 1.5 mm²) EASYBus-connection data: Max. Bus load: 2 EASYBus-standard loads Pipeline length: max. 2 meters Transfer rate: 4800 baud Short-circuit stability: momentary short-circuit-proof Isolation voltage: 500 V DC Power Supply: via USB-interface Operating temperature: -25 ... +50 °C Storage temperature: -25 ...
B07.0.01.6C-01 Page 7 of 8 7. Frequently asked questions (FAQ) 7.
B07.0.01.6C-01 7.5 Page 8 of 8 How to update a driver of an older version or how to uninstall the driver? In order to update the driver, you have to uninstall the “old” driver firstly and install the latest driver afterwards. 1. To uninstall the driver • Make sure that the USB-adapter is not connected. • Go to start \ settings \ control panel and then double-click software. • Search for the entry “CP210X USB to UART Bridge Controller” and click then “Change / remove”. • Click “Yes” at the pop-up window.