User manual

ManualsBrandsGREISINGER ManualsTemperature GaugesTemperature transducer GTMU-MP-3 -50 up to +400 °C Sensor type Pt1000

T20.0.4X.6C-03

GREISINGER electronic GmbH

D - 93128 Regenstauf, Hans-Sachs-Straße 26

 +49 (0) 9402 / 9383-0  +49 (0) 9402 / 9383-33  info@greisinger.de

Transmitter for temperature

from version V3.2 Operating Manual GTMU - MP

Content

1 INTENDED USE 2

2 GENERAL ADVICE 2

3 SAFETY INSTRUCTIONS 2

4 DISPOSAL NOTES 2

5 ASSIGNMENT OF ELBOW-TYPE PLUG (DEPENDING ON TYPE) 3

6 GENERAL INSTALLATION INSTRUCTIONS: 3

7 DESIGN TYPES, DIMENSION 3

8 DISPLAY FUNCTIONS 4

8.1 MEASURING DISPLAY 4

8.2 MIN/MAX VALUE MEMORY 4

9 ERROR AND SYSTEM MESSAGES 4

10 CONFIGURATION OF THE DEVICE 5

11 NOTES TO THE CALIBRATION SERVICES 6

12 SPECIFICATION 6

WEEE-Reg.-Nr.: DE93889386

Summary of content (6 pages)

PAGE 1
T20.0.4X.6C-03 Transmitter for from version V3.2 Operating Manual temperature GTMU - MP Content 1 INTENDED USE 2 2 GENERAL ADVICE 2 3 SAFETY INSTRUCTIONS 2 4 DISPOSAL NOTES 2 5 ASSIGNMENT OF ELBOW-TYPE PLUG (DEPENDING ON TYPE) 3 6 GENERAL INSTALLATION INSTRUCTIONS: 3 7 DESIGN TYPES, DIMENSION 3 8 DISPLAY FUNCTIONS 4 8.1 8.
PAGE 2
T20.0.4X.6C-03 Operating Manual GTMU - MP _____________________________________________________ page 2 of 6 _____________________________________________________________________________ 1 Intended use The device measures the temperature of air or non corrosive / non ionizing gases. The safety instructions (see chapter 3) have to be observed. The device must not be used for purposes and under conditions for that the device had not been designed.
PAGE 3
T20.0.4X.
PAGE 4
T20.0.4X.6C-03 Operating Manual GTMU - MP _____________________________________________________ page 4 of 6 _____________________________________________________________________________ 8 Display Functions 8.1 Measuring display During normal operation the temperature in [°C] or [°F] is displayed. °C SET 1 2 3 8.
PAGE 5
T20.0.4X.
PAGE 6
T20.0.4X.6C-03 Operating Manual GTMU - MP _____________________________________________________ page 6 of 6 _____________________________________________________________________________ 11 Notes to the calibration services Calibration certificates - DKD-certificates - other certificates: If device should be certificated for its accuracy, it is the best solution to return it with the referring sensors to the manufacturer. (please state desired test values, e.g.