User manual

T38.0.0X.6C-03 Page 4 of 7

5. Installation

5.1 Dimensions

5.2 Elbow-type plug installation instruction

To mount the connection cable (3-, or 4-wire depending on type of device) the elbow-type plug

screw has to be loosened and the coupling insert has to be removed by means of a screw driver at

the position indicated (arrow).

Pull out connection cable through fitting and connect to the loose coupling insert as described in

the wiring diagram. Replace loose coupling insert onto the pins at the transducer housing and turn

cover cap with fitting in the direction desired till it snaps on

(4 different starting positions at 90° intervals).

Re-tighten the screw at the angle plug.

5.3 Assignment of elbow-type plug

3-wire-connection (mA or voltage) 4-wire-connection (voltage)

1 = signal + 1 = signal +

3 = supply voltage +Uv 2 = signal –

(4) = supply voltage -Uv 3 = supply voltage +Uv

signal - (4) = supply voltage –Uv

Note: terminal 2 and 4 are connected in the device.

The type current or voltage output is set by works and cannot be changed.