User manual

ManualsBrandsGREISINGER ManualsTemperature GaugesNeedle probe GHM GSF-50TFK 0 up to +100 °C K

Z24.0.06.6C-02

WEEE-Reg.-Nr. DE 93889386

GSF 50TF and GSF 50TFK

Operating Manual

Injection probe

for resistive material moisture measuring device with BNC connector

with integrated temperature sensor (thermocouple type K)



Please carefully read these instructions before use!



Please consider the safety instructions!



Please keep for future reference!

Summary of content (4 pages)

PAGE 1
Z24.0.06.6C-02 Operating Manual Injection probe for resistive material moisture measuring device with BNC connector with integrated temperature sensor (thermocouple type K) GSF 50TF and GSF 50TFK    Please carefully read these instructions before use! Please consider the safety instructions! Please keep for future reference! WEEE-Reg.-Nr.
PAGE 2
Z24.0.06.6C-02 Operating Manual GSF 50TF and GSF 50TFK _____________________________________________________ page 2 of 4 _____________________________________________________________________________ 1 General Note Read this document carefully and get used to the operation of the device before you use it. Keep this document within easy reach near the device for consulting in case of doubt.
PAGE 3
Z24.0.06.6C-02 Operating Manual GSF 50TF and GSF 50TFK _____________________________________________________ page 3 of 4 _____________________________________________________________________________ 4 Measurement Basics The resistance of the medium between the conical metal surfaces (1) and (2) is measured. The medium being measured has to be compressed well enough. The best is, having a constant pressure onto the medium during the measurement.
PAGE 4
Z24.0.06.6C-02 Operating Manual GSF 50TF and GSF 50TFK _____________________________________________________ page 4 of 4 _____________________________________________________________________________ 6 Measuring bales of straw hay bales Always inject the electrodes form the plain side of round bales never from the round side, the probe can be inserted much easier. For strongly pressed bales we suggest the probe GSF 40 or GSF 40 TF instead.