User's Manual

Cleaning Instructions

Your everbeat watch will perform best if cleaned periodically. Use a soft, clean cloth or paper

towel moistened with isopropyl alcohol (at least 70% by volume). Moisten and clean every

surface of the watch especially the underside of the watch body and anywhere it contacts your

skin. You may need to use a cotton swab or Q-tip to effectively clean the screws on the bottom

of the watch. DO NOT use soaps, hand sanitizers or other household cleaners which could cause

skin irritation. DO NOT immerse the watch in liquid. Always allow the band to dry well before

placing it back on your wrist.

Troubleshooting

Cannot pair: If you cannot pair your everbeat watch, try turning Bluetooth off and on, and make

sure the everbeat watch is powered on by putting it on the stand. Make sure that no other phone

or App is paired with your everbeat watch.

Unable to start ECG: The everbeat watch can take a little time to calibrate itself to your body

once it’s connected. You can start/stop the ECG reading to get it adapted to your body. If it ever

fails to record, just stop the process and restart it until it works. This may take several attempts

but once it is calibrated, it should work the first time.

Unable to complete a recording: If the everbeat system records your ECG but does not

completely finish, you can retry the recording until successful. Follow the ECG Recording Tips

from earlier in this guide to improve your results.

Weak or Poor ECG signal: If there is a noisy signal, or no signal being displayed on the graph you

can try these steps:

1) Moisten the index finger you are using to touch the top ECG sensor.

2) Moisten your wrist beneath the everbeat watch.

3) Make sure you are connected to the watch. Choose the CONNECT menu option, and

reselect your watch from the list of AVAILABLE WATCHES.

Bright light coming from the watch during charging: The everbeat watch only takes about 1

hour to charge and the charge will last for several days. Once the watch is charged, take it off the

charger and it won’t emit any light.

ELECTROMAGNETIC & OTHER INTERFERENCES

The everbeat watch has been tested and deemed in conformance with the relevant requirements

in IEC 60601-1-2:2007 Class B for Electromagnetic Compatibility (EMC). Further information may

be found in Appendix 1, EMC Tables.