Assembly Instructions

ASSEMBLY INSTRUCTIONS

FURNITURE PART LIST

ITEM DESCRIPTION

QTY

HEADBOARD 1 PC

SUPPORT BOARD 2 PCS

HARDWARE PART LIST

ITEM DESCRIPTION

QTY

JCBB BOLT M8 x 60mm 4 PCS

M8 FLAT WASHER 4 PCS

M5 ALLEN KEY (BALL SHAPE)

1 PC

STEP 2

STEP 1

STEP 3

Read instructions carefully. See furniture and hardware part

list on the right for guidance.

Have all parts ready before assembly. Place all wooden furniture

parts on a clean and flat soft surface to prevent scratching.

Before you start, here are some words of caution:

1. Do not FULLY - TIGHTEN nuts and bolts until all nuts and bolts are partially tightened.

2. Do not FULLY - TIGHTEN nuts and bolts to avoid causing damage to the threading.

3. Keep all hardware parts out of reach of children.

NOTE : THE LIST AND QUANTITY SHOWN ARE FOR 1 UNIT ASSEMBLY.

Align pre-drilled support stand holes over the

pre-drilled headboard holes according to your

desired headboard height

Secure each support stand by using 2x JCBB Bolt [1]

and 2x M8 Flat Washer [2].

Tighten with supplied Allen Key [3].

Repeat the same procedure to secure the other side.

Your headboard assembly is complete.

Note: Hardware may loosen over time. Periodically

check that all connections are tight.

QUEEN HB

PAGE 1
ASSEMBLY INSTRUCTIONS QUEEN HB Read instructions carefully. See furniture and hardware part list on the right for guidance. Have all parts ready before assembly. Place all wooden furniture parts on a clean and flat soft surface to prevent scratching.
PAGE 2
ASSEMBLY INSTRUCTIONS (BED FRAME) QUEEN HB Read instructions carefully. See furniture and hardware part list on the right for guidance. Have all parts ready before assembly. Place all wooden furniture parts on a clean and flat soft surface to prevent scratching. Before you start, here are some words of caution: FURNITURE PART LIST ITEM A B DESCRIPTION HEADBOARD 1 PC BED FRAME 1 PC 1. Do not FULLY - TIGHTEN nuts and bolts until all nuts and bolts are partially tightened. 2.