Owner Manual

å
Carefully turn the ENDS (A and B) and PANELS (G) over.
å
Turn twelve BLACK 9/16" FLAT HEAD SCREWS (32S) into
the ENDS (A and B) and PANELS (G) until the shoulders of the
SCREWS rest on the surfaces of the ENDS and PANELS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDINGS (K) onto the ENDS (A and B). Line up
the grooves in the MOLDINGS over the heads of the SCREWS in
the ENDS.
å
NOTE: If the MOLDING comes up o of the SCREWS, remove it
and slide it on again.
Step 3
Page 7
These edges
should be even.
These edges
should be even.
BLACK 9/16" FLAT HEAD SCREW
(12 used in this step)
32S
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
A
B
G
G
K
K
Shoulder
NOTE: Use the exact holes
shown in the PANEL (G).
NOTE: Use the exact holes
shown in the PANEL (G).