Installation & Assembly

Step 5
Stand the Table up and check for stability.
Then proceed to tighten all Bolts at all joints.
Note: DO NOT fully tighten a BOLT in one go and then move on to the next. Rather,
in asequential manner, gradually tighten each Bolt until all bolts are evenly secured.
Thismethodology will ensure maximum evenness once all Bolts are fully tightened.
You Bar Table is ready for use .
The Bar Table should only be used on a flat,level surface.
Step 4
Attach Table Top (A)&Left Panel( B)and Right Panel (C)using Bolts(
①
) and Washers(
②
)
③
)
as the picture show.
DO not fully tigthen the Bolts.
Step 6
4 OF 4
C
with Allen Key(