Installation & Assembly

Your Barstool is ready for use.
This Barstool can only be used on a flat and level surface.
Place the Barstool on a LEVEL SURFACE to check for wobbles.
If it wobbles, lift the Barstool some 30cm to 50 cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Barstool freely and vertically with all four legs, hitting the ground, all at the same
time.
This Drop Test will help to ensure that all the Bolts and gaps reach full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found, slowly and steadily, place the Barstool facedown.
Then, proceed to tighten all Bolts in a sequential manner.
When tightening the Bolts, tighten sequentially.
DO NOT tighten any Bolt fully and then move on towards the next one.
This could cause the frame to warp. If there are still wobbles, loosen the Bolts and
execute the same drop test.
If the Barstool is not stable, it could lead to damage to the product.
Step 4
Step 5
4 OF 4