ASSEMBLY & OPERATING INSTRUCTIONS Liquid Propane Gas Grill • Parts • Assembly • Safety Rules • Use and Care • Troubleshooting ! Note to Consumer WARNING: Read this Owner’s manual carefully and be sure your gas grill is properly assembled, installed and maintained. Failure to follow these instructions could result in serious injury and/or property damage. This gas grill is intended for outdoor use only and is not intended to be installed in or on recreational vehicles or boats.
Table of Contents Precautions Warranty........................................................2 Safety Precautions.....................................3-4 Packaging Content List.................................5 Hardware Pack.............................................7 Preparation...................................................7 Assembly Instructions.............................8-14 Lighting Instructions..............................15-16 Cleaning and Maintenance...................
Precautions A tank of approximately 12 inches in diameter by 181/2 inches high is the maximum size LP gas tank to use. You must use an OPD gas tank which offers an Overfill Prevention Device. This safety feature prevents the tank from being overfilled which can cause malfunction of the LP gas tank, regulator and/or grill. • Have your LP gas tank filled by a reputable propane gas dealer and visually inspected and requalified at each filling. • Do not store a spare LP gas tank under or near this appliance.
Burner Flame Check ! WARNING A strong gas smell, or the hissing sound of gas indicates a serious problem with your gas grill or the LP gas tank. Failure to immediately follow the steps listed below could result in a fire or explosion that could cause serious bodily injury, death, or property damage. • Shut off gas supply to the gas grill. • Turn the control knobs to OFF position. • Put out any flame with a proper fire extinguisher. • Open Grill Lid. • Get away from the LP gas tank.
PACKAGE CONTENTS LIST A. Firebox--------1 pc. B. Cart Leg, Front Left------1 pc. C. Cart Leg, Rear Left----1 pc. D, Cart Leg Foot-----2 pcs. E. Side Panel, Left----1 pc. F. Cart Brace, Left------1 pc. G. Cart Leg, Front Right-----1 pc. H. Cart Leg, Rear Right-----1 pc. I. Side Panel, Right----1 pc. J. Cart Brace, Right------1 pc. K. Wheel Axle-----------1 pc. L. Wheel---------------------2 pcs. M. Bottom Panel -----------1 pc. N. Gas Tank Bar Barrier.---1 pc. O. Front Panel A-------1 pc. P.
S. Cart Frame, Rear------1 pc. T. Side Burner bowl assembly frame with Side burner control panel-----1 pc. U. Left side shelf with side shelf front panel---------1 pc. V. Bezel---------------------------1 pc. W.. Control Knob--------------1 pc. X.. 1.5 Volt “AA” Size Alkaline Battery----------1 pc. Y. Grease Tray -1 pc. Z. Grease Box--------------------1 pc. ZA. Flame Tamer------------4 pcs. ZB. Cooking Grid----------------2 pcs. ZC. Warming Rack--------------1 pc. ZD.
Hardware Pack Contents Description Required for assembly (pcs) AA 5/32-in. x 8-mm Round Head Screw 26 BB 5/32-in. Lock Washer 26 CC 1/4-in. x 10-mm Round Head Screw 18 DD 1/4-in. Lock Washer 18 EE Allen Key 1 FF 1/4-in. x 65-mm Round Head Screw 8 GG 1/4-in. Flat Washer 8 / Pack AA BB CC DD EE FF GG Preparation Before beginning assembly, make sure all parts are present. Compare parts with package contents list and diagram above.
Assembly Instructions UNPACKING CAUTION: Obtain the aid of an assistant when handling large or heavy grill components. Fig. 1 C 1. Remove all packing material from around grill exterior. 2. Open Firebox lid and remove packing materials and components from inside Firebox. 3. With the aid of an assistant, lift the Firebox out of the shipping box and place on protected flat surface. Be careful not to damage hose and regulator. 4. Refer to Parts Lists to check that all parts are present. 5.
2. Wheel Assembly R Fig. 5 Remove Axle Bushing (R) and Screws from the ends of Wheel Axle (K). Insert Wheel Axle (K) through Cart Leg, Front Right (G) and Cart Leg, Back Right (H). Place Axle Bushing and Wheel (L), cone side facing Leg, on each end of Axle. Secure Wheels to Axle with previously removed Screws. See (Fig. 5). 3.
5. Front Panel Assembly Fig. 9 (a) Use 2 AA Round Head Screw and 2 BB Lock Washer to attach hadle to Front Panel B (P) (Fig 8). B (b) Use 4 AA Round Head Screws and 4 BB Lock Washer to attach the Front panel A (O), to the Front Left Cart Leg (B ) and Front Right Cart Leg (G),see (Fig. 9). Note: Attach Side Panel so that flat surface is on grill exterior. O (c) Use 4 AA Round Head Screws and 4 BB Lock Washer to attach the Front panel B (P), to the Front Left Cart Leg (B) and Front Right Cart Leg (G) .
(b) Raise firebox lid and from inside the Firebox use 4 CC Round Head Screws to attach the sides of Firebox to Cart Brace, Left (F) and Cart Brace, Right (J). Raise Firebox slightly to align holes for inserting and tightening screws. See (Fig. 13). Fig.13 (c) From the inside of the cart, use 2 CC Round Head Scews and 2 DD lock washers, attch Rear Right Cart Leg (H) and Rear Left Cart Leg (C) to the firebox. 7.
(b) Remove two screws from side burner control valve face. Insert side burner valve control stem through hole in side burner control panel . Place side burner control knob bezel (V) over side burner valve control stem. Secure bezel to control panel and valve with 2 screws removed above. (Fig . 18A1). Fig. 18 B1 (c) Insert side burner tube over side burner valve orifice (Fig. 18B1). Use the two previously removed side burner screws to reattach side burner to side burner shelf.
10. Grease Cup Assembly Fig. 22 From the back, pull in grease tray (Y), remove any packaging materials from it, then insert grease cup (Z) into grease tray (Y) as shown in (Fig.22). Push grease tray back into grill. Z 11. Installing Cooking Components Y (a) Place flame tamer (ZA) over burners as shown. Flame tamer ends insert into channels on front and back of firebox.(Fig. 23) (b) Evenly space cooking grates (ZB) on the ledge above heat diffusers. (Fig.23) Fig.
Important Before cooking on your grill the first time, wash cooking grids and cooking rack with warm , soapy water. Rinse and dry thoroughly. Season with cooking oil regularly. After cooking is completed, turn grill to HIGH setting for 3 to 5 minutes to burn off excess grease or food residue. Congratulations Your gas grill is now ready for use. Before the first use and at the beginning of each season (and whenever the LP gas tank has been changed): 1. Read all safety, lighting and operating instructions.
3. Be sure all gas connections are securely tightened. 4. Turn on gas supply. 5. Open the grill main lid. 6. Push and turn any main burner control knob to HI position. Push Electronic Ignition button for 3 to 5 seconds to light burner. Checking for LP gas leaks Never test for leaks with a flame. Prior to first use, at the beginning of each season, or every time your LP gas tank is changed, you must check for gas leaks. 1. Make a 50/50 (soap/water) mild soap solution. 2.
! WARNING Never lean over the grill cooking area while lighting your gas grill. Keep your face and body a safe distance (at least 18 inches) from the cooking grid surface when lighting your grill by match. Manually Lighting Your Grill by Match 1. Insert a match into the manual lighting stick. 2. Follow steps 1 through 5 of the Basic Lighting Procedure. 3. Light the match and extend the lighting stick to cooking grid surface. 4. Turn the desired control knob to the HI position setting to release gas.
Cleaning Exterior Stainless Steel Surfaces Weathering and extreme heat can cause exterior stainless steel surfaces to turn tan in color. Machine oils used in manufacturing process of stainless steel can also cause this tanning color. Use a stainless steel cleaner to polish stainless steel surfaces of your grill. Never use abrasive cleaners or scrubbers because they will scratch and damage your grill.
! WARNING The location of the burner tube with respect to the orifice is vital for safe operation. Check to ensure the orifice is inside the burner tube before using the gas grill. If the burner tube does not fit over the valve orifice, lighting the burner may cause explosion and/or fire. 2. Clean any clogged ports with a stiff wire, such as an open paper clip. 3. Inspect each burner for damage (cracks or holes) and if such damage is found, order and install a new burner.
Cooking Instructions Indirect Cooking To cook indirectly, the food should be placed on the left or right side of your grill with the burner lit on the opposite side. ! WARNING Do not leave the grill unattended. Your grill will get very hot. Never lean over the cooking area while using your grill. Do not touch cooking surfaces, grill housing, grill lid or any other grill parts while the grill is in operation, or until the grill has cooled down after use.
Cooking Chart FOOD Weight or thickness Temperature Time Special instructions and tips Vegetables NA Medium Slice or chop vegetables and dot with butter or 8 to 20 minutes margarine. Wrap tightly in heavy duty foil. Grill turning occassionally. Potatoes Whole Medium 40 to 60 minutes Meat/Steaks 1/2 to 3/4 inches High-Medium Wrap individually in heavy duty foil. Cook rotating occassionally. Pre heat grill for 15-20 minutes then sear steaks on each side for two minutes.
Model 720-0719BL Parts diagram 02 01 03 04 05 04 07 06 06 08 15 12 11 06 13 14 53 06 52 09 54 51 16 17 21 48 18 19 23 27 50 20 22 47 56 24 57 25 49 55 10 29 46 31 28 29 26 30 33 32 23 24 45 34 36 39 40 37 58 38 40 58 35 39 43 41 44 42 21
Model 720-0719BL Parts List KEY# PARTS DESCRIPTION QUANTI KEY# TY PARTS DESCRIPTION QUANTI TY 1 0719BL-001 Main lid 1 30 0719BL-030 Side Panel,Left 1 2 0719BL-002 Temperature Gauge 1 31 0719BL-031 Cart Frame, Rear 1 3 0719BL-003 Temperature Gauge Housing 1 32 0719BL-032 Gas Tank Barrier Bar 1 4 0719BL-004 Main lid screw 1 33 0719BL-033 Cart Leg Rear, Right 1 5 0719BL-005 Logo 1 34 0719BL-034 Cart Leg Front,Right 1 6 0719BL-006 Hood Buffer 4 35 0719BL-035 Side Panel,R
