Instructions / Assembly

Fig. 22

Fig. 23

Fig. 24

Regulator Connection

10. Grease Cup Assembly

From the back, pull in grease tray (Y), remove any

packaging materials from it, then insert grease cup (Z)

into grease tray (Y) as shown in (Fig.22). Push grease

tray back into grill.

11. Installing Cooking Components

(a) Place flame tamer (ZA) over burners as shown.

Flame tamer ends insert into channels on front and

back of firebox.(Fig. 23)

(b) Evenly space cooking grates (ZB) on the ledge

above heat diffusers. (Fig.23)

the top of firebox side panels. (Fig.23)

Fig. 25

12. Connecting LP Gas Tank to LP Grill

(a) Loosen and take out the bolt pre-assembled on the

inner side of bottom panel,and insert it from the back of

the bottom panel, see (Fig. 24).

(b) From back of the cart, place foot ring of 20 lb tank into

the hole in bottom panel. Make sure the tank valve is in

OFF position. Use the tank bolt to secure the tank in a

fixed position (Fig.24).

mating threads to fit the hose and pressure regulator

assembly provided.

(d) Make sure all burner valves are in OFF position.

(e) Inspect the valve connection port and pressure

regulator assembly. Look for damage or debris. Remove

any debris. Inspect hose for damage. Never use

damaged or plugged equipment.

(f) When connecting pressure regulator and hose

assembly to tank valve, hand tighten quick coupling nut

clockwise to a full stop. (Fig.25) Do not use a wrench to

tighten because it could damage the quick coupling nut

and result in a hazardous condition.

(g) Slowly open tank valve fully (counterclockwise). Use a

soapy water solution to check all connections for leaks

before attempting to light your grill (see page 15 for gas

leak check instructions). If a leak is found, turn tank valve

off and do not use your grill until the leak is repaired.

CAUTION: When the appliance is not in use, gas must

be turned off at the supply tank.