Installation Instructions

INSTALLATION PROCESS
UltraClip
™
®aa
PNEU MATIC INSTALLATION METHOD
UltraClip
™
SKU #230-8112,
8113, 8114
Tools & Materials Needed
Safety Glasses
Step
2
Step
5
Step
3
Step
6
Step
1
Step
4
INSERT PNEUMATIC
SCREWS
INSTALLING CLIPS
AND FASTENERS
INSTALL THE CLIP
ADAPTER
COMPLETE
INSTALLATION OF BOARDS
INSTALL
FIRST BOARD
POSITIONING CLIPS
AND FASTENERS
Insert a sleeve of collated pneumatic
screws into the rear of the magazine.
Pull back the spring coil until it locks onto
the back of the sleeve.
Masterforce
®
Metal
Connector Nailer
SKU 208-5016 and 208-5019
Adapter
SKU #230-8115
HOUSE
Decks running parallel with the house should
start with the clip against the structure, as
shown above.
Slide first board into exposed clip tabs and
continue installation process.
Pneumatic 1½" scrail
SKU #208-2005
IMPORTANT! Read all
instructions carefully and
completely to ensure proper
installation.
WARNING! Parts have
sharp points & edges.
Use extreme caution when
handling & installing. Wear
safety glasses at all times.
FACING
HOUSE
FACING
DECK BOARDS
HOUSE
LEDGER
JOIST
1 To place next deck board into position,
slightly raise outer edge of board and slide
under the rear tabs of the clip until board
contacts the base of the clip.
2 Check gap between boards for consistency.
Apply force to ensure board is fully installed.
Repeat steps 4 thru 6 until deck is complete.
3
⁄
16
1 Align bottom legs of the clip (A) with
magnet so that they rest on the bottom
tabs of the adapter (C).
2 Roll the top of the clip (B) up and onto
the centering tabs of the nose piece
ensuring that the tip of the fastener
penetrates the hole in the clip.
* Note: The length of the clip should be
parallel to the board. Rear legs should
be horizontal with deck joists.
1 Push clip fully into groove so that the
centering prongs on the nailer touch the side
of the decking board. Ensure that the n
ailer
handle is horizontal to the decking joist.
2 Press down on the nailer to disengage the
safety and pull the trigger to install the
screw.
JOIST
BOARD
HOUSE
A
B
C
1 Install the adapter (B) by sliding it over the
centering prongs (A) on the nose of
the nailer.
2 The magnet should seat flush against the
bottom right horizontal surface of the
nailer.
3 Ensure the bottom locating tab is seated in
the groove of the fastener rail.
4 The left side of the adapter (B) must seat
around the bottom outer edges of the nose
of the nailer (A).
A
B
A Centering prongs on the nose of the nailer
B Adapter
A Bottom legs of the clip
B Top of the clip
C Adapter
CORRECT INCORRECT
See instructions provided by manufacturer for further details.
Tech Support: 800-518-3569 toll free
Email: [e-mail]
™