Specification

Senco Type Wide Crown "P" Series
Crown Width:
26.3 - 26.45 mm (1.035 - 1.041")
Radius at inside of Crown:
0.90 mm ( 0.035")
Length. Nominal +0/- 0.4 mm
P12 0.750 - 0.734"
P13 1.00" - 0.984"
P15 1.25" - 1.234"
P17 1.50" - 1.484"
P19 1.75" - 1.734"
P21 2.00" - 1.984"
Legs must be even within
0.35 mm ( 0.14") side to side.
Material: Galvanized steel.
140 KPSI minimum Tensile. (960
N/mm2)
Bend moment Min. = 3.6 lb/in
Original Issue: 11/01/04
Revised:
Legs must be perpendicular to crown
within 0.1 mm (0.004") on either side
.
Minimum between Legs:
23.2 mm (0.913")
Strip Alignment: Crown axis and leg axis.
Maximum deviation from perpendicular in either
direction is 1/2 of leg width.
Glue/Coating Coverage.
If made by reciprocating machine, glue
must cover 75% of surface, and come to
within 0.5 mm (0.020") of the point edge
.
If made from band, the glue must cover the
entire surface, except for the point.
Wire: Nominal Diameter
1.51 mm (0.0595") +/- 0.0125 mm.
Flattened Dimensions:
1.4 - 1.42 mm T x 1.56 - 1.59 mm W.
0.055" T min x 0.0614 - 0.0626" W.