Instructions / Assembly

HINGE SIDE CONVERSION

3/16

13.

With the door open, fit the expander bar onto the bottom of

the door. Close the door and position the expander bar so that

the bar fits snugly against the threshold but does not restrict

door operation. From inside the door, drill holes through the

expander bar and secure the expander bar to the door with

Phillips head screws provided.

Lay the door flat on saw horses or other flat surface, placing

packing carton underneath the door to prevent scratching.

Remove the expander bar from the bottom of the door.

(There are no screws holding expander bar in place). Set the

expander bar aside for later use. (See Step 13 - DOOR

INSTALLATION).

Turn the hinge side of the Z-bar up to expose the hinge

screws. Remove the

2 Phillips head screws from each of the

hinges. Slide the hinge Z-bar toward what is now the bottom

of the door to the next pre-drilled hole. Be sure the holes are

aligned. Replace the 2 Phillips head screws in each of the 3

hinges but do not tighten.

Allow a space between the top of the door and the header cap

of 3/16" on each side. Now tighten the screws in the hinges

and pre-hang clips. Re-install header with existing screws.

Remove the header cap from the top of the door by unscrewing

the 2 Phillips head screws. Remount the header cap on the

opposite end of the door. Replace the 2 Phillips head screws

and tighten securely.

From the lock side of the door, remove the Phillips head screw from

each pre-hung clip. Slide the lock side Z-bar toward what is now the

bottom of the d

oor to the next pre-drilled hole; replace the Phillips

head screws in each of the two pre-hung clips but do not tighten.

Slide lock side jamb upward

and attach screw

Bottom

Pre-hang

clip

Top

Slide hinge side jamb

upward and attach screws