Installation Guide

MailslotInstallationInstructions:

*Important:Installmailslotafterdoorhingereversingprocessiscompleted,ifsorequired.

Step1.Laythedoorflatonaprotectedsurfaceasnottoscratchthedoorfinish.

Step2.Centerthesuppliedmailslottemplateoverthedesignatedexteriorsideofthedoorslot

opening,andsecureinplacewithmaskingorpainter`stape.

Step3.Withthetemplateinplace,drill1/8”inchpilotholesatthecenterofthefourmarkedlocations

onthetemplate.(Carefulnottodrillentirelythroughbothsidesofthedoor)

Step4.Removethetemplateandpositionthemailslotintheproperorientationandinalignmentwith

thefourpilotholes.

Step5.Securethemailslotinplacewithfourofthesupplied#8x½”self‐tappingcountersunkscrews.

Installationiscomplete.



PAGE 1
Mail slot Installation Instructions: *Important: Install mail slot after door hinge reversing process is completed, if so required. Step 1. Lay the door flat on a protected surface as not to scratch the door finish. Step 2. Center the supplied mail slot template over the designated exterior side of the door slot opening, and secure in place with masking or painter`s tape. Step 3. With the template in place, drill 1/8” inch pilot holes at the center of the four marked locations on the template.