Installation Guide

SL-H536-200G
INSTALLATION INSTRUCTIONS
STEP 1 LATCH ASSEMBLY
A. From outside of door, determine if your door is a right hinged
or a left hinged door.
See Fig. 1-A.
LEFT HIN GED
RIGHT HINGED
~
~
OUTS ID E HANDLE
OUTSIDE HAN DLE
~
~
INSIDE HANDLE I NSIDE HANDLE
FIGURE 1-A
B. Determine if angl ed part of the "lat ch bolt" faces the correct
di rection for e it her left or ri ght hinged door (see Figure #1 ). If
latch bolt needs to be rotated, see Figure 2 & 3. If latch bolt
is in correct position, go to step D.
C. To reverse the direction of the latch bolt, push in the latch bo lt
and remove the latch screw at the same time (see Figure #2).
Then remove latch bolt, rotate to correct position and reinsert
(see Figure #3). Replace latch screw.
0. Insert latch assembly into end of door panel per Figure #4 .
Do NOT fasten at this time. Will be fastened at step 2-E.
FIGURE 1
FIGURE 2
LEFT HIN&EO Rl6HY HIN6EO
PUSH LATCH 80L T IN TO REVEAL LATCH SCREW
LATCH BOL T ~
•
LATCH BOLT
LATCH
SCREW
0 0
FIGURE 3
RO TATE 180 ' ~
@
STARTING POSIT JON
(LEFT HINGED)
E. Insert double key cylinder through the latch assembly, aligning the screw hole in the key cylinder
wi
th the hole in the mortise plate. Insert the #10-32 x 1-1/2" flat head screw into the mortise plate
and key cylinder. Prior to tightening the screw, turn the key cylinder
to extend the deadbolt. See
Figur~ 5. Return the deadbolt to the fully retracted position after ti ghteni ng t he screw.
FIGURE 4
4 ; _
LATCH
ASSEMB LY 0
0
MORTISE
PLATE
jMQ.-32 x 1-1~
PH Fl. SCREW
FIGURE 5
..
• 0
OUTSIDE
OF DOOR
~~~LEKEY
~ONOEA