Full Product Manual

G0513 Series Bandsaws (Mfd. Since 07/18)
-27-
5. Install the fence on the left-hand side of the
blade.
6. Place the fence flush against the bandsaw
blade (see Figure 31).
Figure 31. Fence flush with blade.
8. Re-tighten the pointer adjustment nut.
7. Loosen the pointer adjustment nut (see
Figure 32) and set the pointer in line with "0"
on the measurement scale on the rail.
Figure 32. Calibrating fence pointer
(adjustment nut out of view).
Pointer
Pointer Nut
1. Place the 8mm flat washer on the locking
handle (see Figure 33), slide it through the
hole in the fence, then thread the moving
plate onto the end of the locking handle
threads.
2. Slide the resaw fence over the moving plate,
as shown in Figure 33, so the moving plate
fits inside the channel of the resaw fence,
then tighten the locking handle.
Installing Resaw Fence (G0513X2,
G0513X2B, G0513X2BF & G0513X2F)
Figure 34. Resaw fence properly installed.
Locking Handle
Resaw
Fence
Figure 33. Attaching resaw fence.
Resaw Fence
Moving
Plate
Locking
Handle