Use and Care Manual

-20-

G0513 Series Bandsaws (Mfd. Since 07/18)

Figure 14. Other bandsaw components.

G0513X2B & G0513X2BF

Shipping Inventory (Figures 13–14) Qty

A. Bandsaw (not shown) ................................. 1

B. Table ........................................................... 1

C. Miter Gauge ................................................ 1

D. Resaw Fence ............................................. 1

E. Front Rail .................................................... 1

F. Fence Assembly ......................................... 1

G. Guide Post Handwheel............................... 1

Hardware & Tools (Not Shown) Qty

• Flat Washers 8mm (Table, Fence, Rail) ..... 8

• Lock Washers 8mm (Table, Rail) ............... 5

• Hex Bolts M8-1.25 x 25 (Table) .................. 4

• Hex Bolt M8-1.25 x 90 (Positive Stop) ........ 1

• Hex Nut M8-1.25 (Positive Stop) ................ 1

• Cap Screws M6-1 x 20 (Rail) ..................... 3

• Cap Screw M8-1.25 x 20 (Rail) .................. 1

• Lock Washers 6mm (Rail) .......................... 3

• Flat Washers 6mm (Rail) ............................ 3

• Table Pin..................................................... 1

• Table Inserts ............................................... 2

• Locking Handle M8-1.25 x 44 (Fence) ....... 1

• Moving Plate (Fence).................................. 1

• Knobs M8-1.25 x 20 ................................... 2

• Rail Plates .................................................. 3

• Hex Wrench 5mm, 8mm....................1 Each

• Open End Wrench 10 x 13mm ................... 1

Figure 13. Table and miter gauge.