Use and Care Manual

-16-
Model G0529 (Mfd. Since 04/17)
To square the sanding tables:
1. DISCONNECT MACHINE FROM POWER!
2. Set the table at 90˚, as shown in Figure 9.
3. Place a machinist's square on the table and
against the sanding spindle to verify the
table is 90˚ from the edge of the sanding
sleeve as shown in Figure 10.
4. Adjust the pointer to 90˚.
Figure 10. Squaring the table and spindle.
Figure 8. Installing table inserts.
Squaring TableTable Inserts
The table inserts minimize the gap between the
working surface edge and the spindle. It is impor-
tant to use the proper table insert according to the
diameter spindle you are using.
The Model G0529 comes with the following four
table inserts:
• 2"
• 1"
• 2" elliptical
• 1" elliptical
Select the table insert that comes closest the
spindle sleeve diameter without touching it. The
elliptical inserts are used when sanding with the
table tilted.
Place the table insert into the table hole, as
shown in Figure 8.
Figure 9. Setting the table scale at 90˚.
Pointer