Use and Care Manual

Model G0529 (Mfd. Since 04/17) -17-
Figure 11. Squaring the sanding table.
5. If the table is not 90˚ from the spindle, adjust
the table stop bolt to allow more table travel,
as shown in Figure 11.
Squaring Disc
Sander
The sanding tables for the spindle sander and the
disc sander have tilting capabilities from 0˚ to
45˚.
To tilt the sanding table:
1. DISCONNECT MACHINE FROM POWER!
Figure 12. Squaring the disc sanding table.
3. Loosen the lock lever and adjust the table
angle until it is perfectly perpendicular and
flush with both edges of the machinist 's
square.
4. Tighten the lock lever while holding the table
perpendicular.
5. Adjust the scale pointer to read 0˚ when the
table has been properly adjusted.
6. Tighten the table stop bolt against the under-
side of the table when the table is set at
90˚.
2. Using a machinist's square, set one edge on
the table surface and the other against the
face of the sanding disc, as shown in Figure
12.
Note: This can be done with the sandpaper
installed, although it is somewhat easier to
measure if the disc does not have the sand-
paper disc installed.