Use and Care Manual

-20-
Model G0529 (Mfd. Since 04/17)
The Model G0529 sander is equipped with a
paddle-type power switch with a safety key.
To operate the power switch:
1. Insert the safety locking key shown in
Figure 16.
Figure 16. On/Off Switch.
2. Lift the switch to start motor. Press switch to
stop the motor.
3. Remove the locking key when the machine is
not in use and store the key in a safe place.
Make sure power switch is in OFF position
before connecting sander to power. Serious
personal injury could occur if machine is
connected to power with power switch ON.
Power Switch
SECTION 4: OPERATIONS
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the
machine controls/components
discussed later
in this manual
are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual,
seek additional
training from experienced
machine operators
, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
To reduce risk of eye injury from flying
chips or lung damage from breathing dust,
always wear safety glasses and a respirator
when operating this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.