Use and Care Manual

-26-
Model G0529 (Mfd. Since 04/17)
Machine Operation (Continued)
Symptom Possible Cause Possible Solution
Glazed sanding sur-
faces.
1. Sanding wet stock.
2. Sanding stock with high residue.
1. Dry stock properly before sanding.
2. Use different stock. Or, accept the characteristics of
the stock and plan on cleaning/replacing sleeves/
discs frequently.
Burn marks on
workpiece.
1. Using too fine of sanding grit.
2. Using too much pressure.
3. Work held still for too long.
1. Use coarser grit sanding sleeve/disc.
2. Reduce pressure on workpiece while sanding.
3. Do not keep workpiece in one place for too long.
Machine slows
when operating.
1. Applying too much pressure to workpiece.
2. Undersized circuit or extension cord used.
1. Sand with less pressure—let the movement of the
sleeve/disc do the work.
2. Make sure circuit wires are proper gauge & don’t use
extension cords!
Machine vibrates
excessively.
1. Stand not stable on floor.
2. Incorrect motor mounting.
3. Incorrect sanding sleeve tension.
4. Broken/defective sanding sleeve/disc.
1. Secure stand to floor, reposition to level surface, or
shim stand.
2. Check/adjust motor mounting.
3. Make sure tension lever is in tensioning position.
Follow sleeve tensioning instructions in this manual.
4. Replace sanding sleeve/disc.
Workpiece frequent-
ly gets pulled out of
your hand.
1. Not supporting workpiece against stable.
2. Starting the workpiece on a leading corner.
1. Use table to support workpiece.
2. Start workpiece on a trailing corner.