Use and Care Manual

-20-
Model G0442/G0601 (Mfg Since 3/12)
Assembly
The Model G0442/G0601
is a heavy machine.
Serious personal injury
may occur if safe moving
methods are not used. To
be safe, get assistance
and use power equip-
ment to move the ship-
ping crate and remove
the machine from the
crate.
To assemble the dust collector:
1.
Connect the upper stand legs with the lower
stand braces, using (16)
3
⁄8"-16 x
3
⁄4" hex bolts,
(32)
3
⁄8" flat washers, and (16)
3
⁄8"-16 lock nuts
(see Figure 10).
Note: Do not fully tighten the fasteners for
now.
Figure 10. Initial assembly of upper stand legs
connected to lower stand braces.
x 16
2.
Attach the upper stand braces to the top of
the assembly from Step 1, using (16)
3
⁄8"-16
x
3
⁄4" hex bolts, (32)
3
⁄8" flat washers, and (16)
3
⁄8"-16 lock nuts, as shown in Figure 11.
Note: Do not fully tighten the fasteners for
now.
Figure 11. Upper braces attached to stand
assembly.
x 16
3.
Square up the stand, as shown in Figure 12,
then tighten all the bolts.
Figure 12. Squaring stand assembly before
tightening stand hardware.