Use and Care Manual



9. 
      

10. 
11.      
Figure 10     
        

Figure 11

Step 15
      
Steps 12–14
12.       
Figure 9)
Figure 11.
Cutterhead
Pulley
Motor
Pulley
!LIGNMENT
Figure 13
18 


 NoteThe guard may not fully seat in the hole
initially; however, rotating the guard will allow
the shaft to fully seat in the hole.
Figure 10
13.       


14. 
15.      


Figure12
16. 
Figure12.
17 Figure
13
Figure 12.
