Use and Care Manual
Figure 17.
Dust Collection
To connect a dust collection hose:
1. Figure
17
DO NOT operate the Model G0656 without an
adequate dust collection system. This jointer
creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
2.
Figure 17
3.
Note: A tight fit is necessary for proper
performance.
Figure 18.
Ide9ZVY
8ZciZg
Setting Outfeed
Table Height
To set the outfeed table height:
1.
2.
3.
Figure 18
4.
Figure 19
Figure 19.
HigV^\]iZY\Z
*
$
('
Dji[ZZY >c[ZZY










