Use and Care Manual






Squaring stock involves four steps performed
in the order below:
1. Surface Plane On The Jointer







2.Surface Plane On a Thickness Planer


3. Edge Joint On The Jointer


4. Rip Cut On A Table Saw


Squaring Stock
        
          
Figures 26 & 27


NOTICE
If you are not experienced with a jointer,
set the depth of cut to 0", and practice
feeding the workpiece across the tables as
described. This procedure will better pre-
pare you for the actual operation.
Figure 27.
Figure 26.
Surface Planing