Use and Care Manual

-52-
Model G0813/G0814 (Mfd. Since 3/16)
Aligning Pulleys
Pulley alignment is another important factor in
power transmission and belt life. The pulleys
should be parallel to each other and in the same
plane (coplaner) for optimum performance.
The pulleys can be adjusted by loosening the
pulley set screws, aligning the pulleys, and
retightening the set screws.
Tool Needed Qty
Hex Wrench 3mm .............................................. 2
Straightedge ...................................................... 1
To align pulleys:
1. DISCONNECT MACHINE FROM POWER!
2. Remove cabinet rear access panel and belt
guard.
3. Place straightedge against pulleys to check
their alignment (see Figure 86).
Cutterhead
Pulley
Motor
Pulley
Alignment
Figure 86. Checking pulley alignment.
Straightedge
— If they are not aligned, loosen set screws
on cutterhead or motor pulley as needed
to align pulleys, then tighten set screws
(see Figure 87).
4. Replace cabinet rear access panel and belt
guard.
Figure 87. Motor pulley set screw locations.
Pulley
x 2
Note: This can also be done visually (without
a straightedge) if you do not have a straight-
edge available that will fit; however, the
most accurate results will come from using a
straightedge.