Use and Care Manual

-14-

Model G0815 (Mfd. Since 09/18)

Inventory

The following is a list of items shipped with your

machine. Before beginning setup, lay these items

out and inventory them.

If any non-proprietary parts are missing (e.g. a

nut or a washer), we will gladly replace them; or

for the sake of expediency, replacements can be

obtained at your local hardware store.

NOTICE

If you cannot find an item on this list, care-

fully check around/inside the machine and

packaging materials. Often, these items get

lost in packaging materials while unpack-

ing or they are pre-installed at the factory.

Inventory (Figure 6) Qty

A. Dust Hood .................................................. 1

B. Phillips Head Screws 10-24 x

⁄8 ................ 4

C. Lifting Bars ................................................. 4

D. Knife-Setting Jig ......................................... 1

E. Feed Rate Control Knob

⁄8 - 1 6 ................... 1

F. Open-End Wrenches 8/10, 12/14mm ...1 Ea.

G. T-Handle Hex Wrench 5mm ....................... 1

H. Hex Wrenches 3, 4, 5, 6mm .................1 Ea.

Figure 6. Model G0815 loose inventory.