Use and Care Manual

Model G0857/G0858 (Mfd. Since 02/19)
-37-
Lubrication
T27914—Moly-D Machine & Way Oil ISO 68
Moly-D oils are some of the best we've found for
maintaining the critical components of machinery
because they tend to resist run-off and maintain
their lubricity under a variety of conditions—as
well as reduce chatter or slip.
Figure 36. T27914 Moly-D Machine & Way Oil.
Lubrication
Fence & Carriage
Oil Type .... Grizzly T27914 or ISO 68 Equivalent
Oil Amount ...........................................1–2 Drops
Lubrication Frequency .... Monthly, or As Needed
Clean fence pivot points and carriage ways (see
Figure 35) with mineral spirits and shop rags,
allow to dry, then lubricate with light machine oil.
Wipe off excess oil.
Since all bearings are sealed and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
It is essential to clean components before lubri-
cating them because dust and chips build up on
lubricated components and make them hard to
move. Simply adding more grease to them will not
yield smooth-moving components.
Item(s) Needed: Qty
Pump-Type Oil Can ........................................... 1
Mineral Spirits .................................... As Needed
Clean Shop Rags .............................. As Needed
Figure 35. Fence and carriage lubrication
locations.