Use and Care Manual

Model G0857/G0858 (Mfd. Since 02/19)
-3-
Identification
Become familiar with the names and locations of the controls and features shown below to better understand
the instructions in this manual.
For Your Own Safety Read Instruction Manual Before Operating Jointer
a) Wear eye protection.
b) Always keep cutterhead and drive guards in place and in proper operating condition. If
removed, ALWAYS replace cutterhead guard immediately after rabbeting operations.
c) Never make cuts deeper than
1
⁄8"per pass.
d) Always use hold-down or push blocks when jointing material narrower than 3" or planing
material thinner than 3".
e) Never perform jointing, planing, or rabbeting cuts on pieces shorter than 10" in length.
Cutterhead
Guard
Depth-of-Cut
Scale
Infeed
Table
Infeed Table
Adjustment Lever
Infeed Table
Lock
Outfeed Table
Lock
Outfeed Table
Adjustment Lever
Outfeed
Table
Fence
Fence Tilt Lock
4" Dust
Port
Fence Tilt
Handle
Rear Access
Panel
Push Block
Holders
(2 of 4)
Fence Lock
Lever
Fence
Adjustment Knob
Mobile Base Lock Knobs
ON/STOP Switch
Infeed Table Stop
Release Knob