Use and Care Manual

G0548ZP, G1028Z2, G1029Z2-Z2P (Mfg. 12/12+)
-21-
3. Insert the rubber gasket between the collec-
tor and outlet flange, and secure the flange
with (8)
5
⁄16"-18 x
1
⁄2" flange bolts, as shown in
Figure 25.
Note: When connecting parts that have a gas-
ket applied to the mounting surface, always
tighten the fasteners in a crisscross man-
ner to ensure the gasket does not become
crimped and the seal compromised.
Figure 25. Mounting outlet flange to collector
body.
4. Attach the lower collector support brackets to
the top edge of the base plate using (4)
5
⁄16"-
18 x
1
⁄2" flange bolts, as shown in Figure 26.
Figure 26. Mounting support bracket to base.
Lower
Support
Brackets
x 4
x 8
5. Secure the front lower support bracket to the
collector with (2)
5
⁄16"-18 x
1
⁄2" flange bolts.
6. Place the upper support bracket over the rear
lower support bracket, and secure them to
the collector with (2)
5
⁄16"-18 x
1
⁄2" flange bolts,
as shown in Figure 27.
Figure 27. Mounting collector to brackets.
Collector
Upper Support Bracket
Lower
Support
Bracket
x 4
Note: The collector attaches to each sup-
port bracket. The inside of the collector is
funnel shaped and directs the air around in
a cyclone motion. Make sure that the inside
taper (funnel) is faced downward and the col-
lector inlet faces toward the motor, as shown
in Figure 28.
Collector Body
Inlet
Inside
Taper
Figure 28. Collector attached to support
brackets.
Outlet Flange
Put Gasket Here