Use and Care Manual

-12-
Model G9956 (Mfg. Since 8/15)
Power Connection
Connecting Power
Figure 4. Connecting power.
1. Turn the machine power switch OFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
1. Set the main switch to "Remote Control."
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
Disconnecting Power
Figure 5. Disconnecting power.
1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
1. Turn the switch to "Remote Control."
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
Test Run
Before you install the model G9956, bench-test
the unit to make sure it runs properly.
Note: Do not be alarmed if you notice a small
amount of vibration during the Test Run. It is nor-
mal for all air filters to produce a small amount of
vibration during operation. This vibration is much
more noticeable when operating on a hard sur-
face, such as a workbench, compared to when
operating in a suspended position, as designed.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, disconnect it
from power, then review the Troubleshooting on
Page 20.
If you still cannot remedy a problem, contact our
Tech Support at [phone] for assistance.
To test run the machine:
1. Place the air filter unit on the floor or a sturdy
workbench.
2. Push the main switch to "Remote Control."
This will ensure the air filter is OFF.
3. Connect the unit to the power source.
4. Push the main switch to "No Remote Control,"
then pull the switch chain to turn the fan ON.
7. Listen to and watch for abnormal noises or
actions. The machine should run smoothly
without rubbing noises.
8. Pull the switch chain to turn the fan OFF.
9. Set the main switch to "Remote Control."
10. Push the ON/HR button on the remote control
to turn the air filter ON, then push OFF to turn
the filter OFF.
Remote Control
Install the included 9V battery in the remote con-
trol. Refer to Page 21 for additional information.