Use and Care Manual

Model G9956 (Mfg. Since 8/15)
-17-
Fan Speeds & Timer
You can adjust the fan speed and the length of
time the air filter operates by programming it with
the included remote control. The ON/HR button
allows you to toggle between fan speed and timer
control functions.
The five speed lights correspond to the five fan
speeds. The following table shows the correlation
between the number of lights illuminated on the
remote and the fan speed.
Setting Fan Timer
1. After setting the fan speed, press the ON/HR
button.
—If some or all of the lights in the upper
row come on, press the ON/HR button
once more.
2. Press the increase button to increase the
amount of time the fan runs before automati-
cally shutting off.
—Each time this button is pressed, the
amount of time increases by two hours,
up to a maximum 8 hour cycle. The
light for the selected time illuminates
on the remote control (see Figure 12).
Figure 12. Example of time set for 6 hours of
operation.
ON/HR OFF
CONTINUE
HOUR
2468
SPEED
Hour
Light
at
6 Hours
3. Decrease the amount of time the fan runs
before automatically shutting off by pressing
the decrease button.
Note: If the automatic shutoff feature will not
be used, press the decrease button until the
continue light is illuminated.
No. of Lights Fan Speed
1 800
2 900
3 1000
4 110 0
5 1200
Setting Fan Speed
1. Press the ON/HR button (see Figure 11)
once to start the fan. The fan should start to
run.
—If one or more of the lower lights
comes on, press ON/HR again.
ON/HR OFF
CONTINUE
SPEED
HOUR
2 4 6 8
Figure 11. Example of fan speed set at 3.
Decrease
ON
Button
OFF
Button
Increase
2. Increase the fan speed by pressing the
increase button (the right hand pointer).
—Each time this button is pressed, the
fan speed increases. The light for the
selected fan speed illuminates on the
remote control.
3. Decrease fan speed by pressing the decrease
button designated by the left hand pointer.