Instructions

56
GB
K L M N O P Q R S T
U V W X Y Z
A B C D E F G
H I J
Installing/Removing the
Reel Capsule
Dismantling the metal cutting blade
is described in the section on “In-
stalling/Removing the Metal Cut-
ting Blade”.
Installing the protective cover / thread
reel:
1. Screw the protective cover / reel capsule
onto the protective cover / metal cutting
blade using the 4 screws enclosed.
Installing the reel capsule:
2. Screw the reel capsule anticlockwise
onto the cutting head holder by
hand, as indicated in the diagram.
3. Remove the protective cap on the thread
cutter.
Removing the reel capsule:
4. Unscrew the reel capsule clockwise
by hand. To make the work easier,
the cutting head holder and bottom
ange can be locked using the enclosed
metal pin (see also ).
5. Remove the protective cover and pull
the protective cap over the thread cut-
ter.
Initial Operation
Warning! Before initial opera-
tion of the equipment, it must be
checked that the condition is safe
for operation. If there is any doubt,
do not start the equipment.
Observe the following points in particular:
• Check the cutting tools for damage and
wear.
• Correct installation of the cutting head
• Easy movement of all switches
• Ensure the handles are clean in order to
be able to guide the equipment safely.
• All safety and protective devices must be
properly installed and in place before the
equipment can be started.
The cutting head must be able to run
freely.
Before starting the equipment, ensure that
the cutting head is sitting correctly and that
the moving parts are free.
Warning! If there is any doubt,
seek help with the operation of
this equipment from a specialist in
an authorised service centre.
Putting on the Carrying Strap
Always wear a shoulder strap
when working with the equipment.
Always switch o󰀨 the equipment
before loosening the shoulder
strap. Risk of accidents.
1. Put on the carrying strap ( 10).
2. Adjust the strap so it ts tightly.
3. Adjust the strap so the spring clip is
around 10 cm below the hip.
4. Fix the spring clip onto the lifting ring on
the shaft tube of the equipment.
Operation
Working Notes
• When cutting, observe the country-
specic / local regulations.
• Do not cut during commonly applica-
ble quiet periods.
• Solid objects such as stones, metal
pieces or similar must be removed.
These can be thrown out and there-
fore result in personal or property