Operation Manual
26
GB
General working instructions
While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to cut-
ting head damage. If the blades be-
come blocked by solid objects, switch
off the unit at once.
• Check the grass and bush trimmer blades
for obvious defects such as loose, worn
or damaged parts. Check that the screws
are seated rmly in the blade block.
• Remove the power supply unit before
working with the equipment. Do not use
extension cables. The power supply unit
is to be used only in enclosed spaces.
• Only use sharp blades to achieve a good
cutting performance and preserve the bat-
tery.
• Do not work the unit so hard that it comes
to a standstill.
• Pay attention to the instructions on unit
maintenance and cleaning.
Use as a grass trimmer
• Grass is best cut when dry and not too
long.
• The telescopic shaft makes it easier to
work with the grass trimmer:
Push the equipment slowly over the
ground on the rollers. This will give an
even cutting height.
• Press the yellow stop button (2)
on the
left of the equipment. The cutting head
(10) can now be swivelled upwards or
downwards.
• Push down the locking bolt (8) on the
back of the equipment and turn the unit
handle (6) at the same time. It clicks into
the desired position.
2
10
8
6
• Push the equipment slowly over the
ground on the wheels. This will give you
an even cut height.
• To cut sloping or vertical edges, the equip-
ment holder (19) on the telescopic handle
can also be turned.
Press the yellow stop button (2) on the
telescopic handle and turn the equipment
holder (19) at the same time. There are 5
possible positions.
Use as a hedge trimmer
Do not use the shrub cutter in com-
bination with the telescopic shaft.
There is a risk of cut wounds.
• Move the unit forward evenly.
• The double-sided cutting heads enable
cutting in both directions or by swinging
the unit from side to side.
20
19