Operation Manual
GB
32
Insert/remove battery
ignition key (13) and wait for the
blades to come to a stop. There is
a risk of personal injury.
G
1. To insert the battery (12) into the
device, push the battery along
the guide rail into the device. It
locks into place audibly.
2. To remove the battery (12) from
the device, press the release
button (12a) on the battery and
pull the battery out.
Charge battery
Allow a freshly charged battery
(12) to cool down for approx. 15
minutes before inserting it into the
battery charger (18).
I
1. Remove the battery (12) from
the appliance, as necessary.
2. Insert the battery (12) in the
charging compartment of the
battery charger (18). It will au-
dibly snap in.
3. Plug the battery charger (18)
into a mains outlet.
4. When the battery is fully rechar-
ged unplug the battery charger
(18) from the mains.
5. Press the release button (12a)
on the battery (12) and pull the
battery out of the battery char-
ger (18).
Used batteries
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see “Waste Disposal and
Environmental Protection”).
Working with the Lawnmower
Regular mowing encourages increased
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Run the equipment at a walking pace,
in tracks that are as even as possi-
ble. For gap-free mowing, the tracks
should always overlap by a few cen-
timetres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when go-
ing backwards and pulling the equip-
ment.
• Clean the equipment after each
use, as described in the chapter on
“Cleaning, Maintenance and Storage”.
Switch o the equipment after
work and in order to transport
it, disconnect the plug and wait
until the blade stops. There is a
risk of injury.