Operation Manual

88
GB
6. Push the choke lever to the middle,
part-throttle position and allow the
motor to warm up in neutral for one to
two minutes.
7. When the motor has warmed up, push
the choke lever to the operating posi-
tion (sun symbol).
The sun symbol is also the start position
for the choke lever when the motor is
warm.
Stop the Motor
1. Release the throttle.
2. To switch off the ignition, move the
stop switch to position
STOPP
.
To stop the motor in an emergency,
push the on/off switch.
Before switching on device, make
sure it is not in contact with any
objects. Ensure stable positioning.
The device can only be switched
on if the entire blower / suction
tube is correctly mounted.
1. Put on the carrying strap and ad-
just it to the optimum length.
2. In order to select the operation
mode, turn the operation mode
selector (11) to the symbol re-
quired.
Before changing the operat-
ing mode, it is absolutely
necessary that the device be
switched off.
Blowing operating mode
Suction operating mode
3. For switch-on, slide the on/off switch
(3) into position “l”.
To switch off, slide the on/off switch
(3) into position
STOPP
, the device
switches off.
Working with the leaf blower
The leaf blower may only be used
for the following purposes:
- As a blower to pile up dry leaf
material or to blow material out
of places that are hard to access
(e.g. under cars)
- As a suction device to suck up
dry leaf material. The device also
functions as a shredder in the
suction function. The dry leaves
are shredded and their volume is
reduced, preparing the material
for later composting if desired.
The shredding intensity depends
on the size of the leaf material
and its residual moisture.
Uses other than those described
here may damage the machine
and put the operator at risk.
During work, ensure that the device
is not struck against hard objects,
which can cause damage. Do not
suck up any solid bodies such
as stones, branches or pieces of
branch, r cones or similar, since
these can damage the device, in
particular the shredding mechanism.
Repairs of this type are not cov-
ered by the guarantee.
C
Blowing operating mode:
• Set the operating mode selector
switch (11) to the symbol .
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.